chevron_left
chevron_right
Out-of-Stock 1:87
Digital
Gran, 19 cm hög, fallande träd, digitalt
This article can only be ordered with payment method invoice or collect in our store.
Gran, 19 cm hög, fallande träd, digitalt
Subscribe To When In Stock
-
Secure payment in our shop!
Description
Gran, 19 cm hög, fallande träd, digitalt, trädet faller sakta mot marken, sen ställer det sig automatiskt upp.
Passar till Viessmann 5141, man med motorsåg
The »digital tree« is falling realistically like a typical tree: starting to tip over slowly, then faster due to overbalancing and finally reaching the ground with a slight bounce. After a short time the tree is automatically stood up again and the spectacle can begin again. The fall is triggered by an integral switch. Alternatively it can be released by a pre-installed digital decoder and a digital control system. The digital decoder is programmable and automatically recognizes the Märklin ®/Motorola and the DCC / NMRA format. With smaller digital controllers, e.g. »Märklin ® Mobile Station 60652«, the digital tree can be released using a locomotive address. By using DCC the release can also be triggered from a locomotive address. Special tip for digital fans: If the tree is falling near a track, the following scenario can be replicated on your model layout: lights on, signals to red, trains stopping ... Note: On the modelling community www.mymocom.com you can present your spectacle of the falling tree to other like-minded people. »Digital tree« highlights: , Natural tree with servo motor and switch , Multi-protocol digital decoder for Märklin ®/Motorola and DCC / NMRA , Release by solenoid address or locomotive address.
Passar till alla skalor.
Passar till Viessmann 5141, man med motorsåg
The »digital tree« is falling realistically like a typical tree: starting to tip over slowly, then faster due to overbalancing and finally reaching the ground with a slight bounce. After a short time the tree is automatically stood up again and the spectacle can begin again. The fall is triggered by an integral switch. Alternatively it can be released by a pre-installed digital decoder and a digital control system. The digital decoder is programmable and automatically recognizes the Märklin ®/Motorola and the DCC / NMRA format. With smaller digital controllers, e.g. »Märklin ® Mobile Station 60652«, the digital tree can be released using a locomotive address. By using DCC the release can also be triggered from a locomotive address. Special tip for digital fans: If the tree is falling near a track, the following scenario can be replicated on your model layout: lights on, signals to red, trains stopping ... Note: On the modelling community www.mymocom.com you can present your spectacle of the falling tree to other like-minded people. »Digital tree« highlights: , Natural tree with servo motor and switch , Multi-protocol digital decoder for Märklin ®/Motorola and DCC / NMRA , Release by solenoid address or locomotive address.
Passar till alla skalor.
Specification
51020
- Scale
- 1:87
- Option
- Digital
16 other products in the same category:
